Six-Foot Ladder Shelf With Laser-Cut Shelves and Printed Connectors

Nov 21, 2026 Last reply: 2 hours ago 2 Replies
Jump to replies (2)

The starting point here is a fun one: taking a plain shelving unit and deliberately over-engineering it with a 3D printer and a laser cutter. Embrace Making set out to inspire anyone hunting for DIY furniture ideas, and the result is a custom six-foot ladder shelf built entirely from scratch. That framing appeals to me a lot, since it treats furniture as a playground for modern tools rather than just a woodworking exercise.



The construction mixes approaches nicely. The five tiers have curved edges and are cut from 3/4-inch maple plywood, while the frame relies on wooden dowels for the vertical and angled supports. What ties it together are 3D-printed connector pieces, plus white printed sleeves and foot components that link the dowels. I think blending printed joints with timber like this is a smart way to get geometry that plain joinery would struggle to match.



The workflow stands out too. Clear acrylic templates, 3 mm thick and labeled SHELF 1 through SHELF 5, were laser cut and engraved, then screwed to matching wood blanks. The software's overhead camera view helped position cuts away from knots, and vectors were offset by 2 mm before cutting at 2 mm/s and 95% power. Since laser cutting charred the plywood edges, that offset left extra material, and a router table with a bearing-guided flush-trim bit sheared the charred perimeter back to the template contour. To me, planning for the charring in advance seems like the cleverest part of the whole build.



The exhaust side got the same treatment, with an inline IF2 fan, an AP2 MAX filtration system, and printed 90-degree adapters, hose splitters, and 4-inch duct fittings. One open question remains: the maker has asked whether viewers want the design files released, and I would love to see them shared.



Project by Embrace Making. Watch it on their YouTube channel:

formatting link


The 2 mm offset trick is the choice I keep coming back to. Laser cutting always chars plywood edges, so baking that trim allowance into the cut vectors and then cleaning it up on a router table with a template seems far smarter than trying to sand char off a finished curve. It does add a whole routing stage to the project, which is a real cost in time, but the payoff is clean curved edges on every tier. A neat bit of planning.

Since the maker has asked whether people want the design files released, my suggestion is to share them. The connector pieces and the acrylic template approach are the parts other builders would benefit from most, and releasing the files would let others adapt the five-tier layout to different heights or shelf widths without redoing the CAD work from scratch. It also fits the stated goal of inspiring DIY furniture ideas, and it would be interesting to see what variations people come up with from the same connectors.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required