Four-Wheel Printed Omnidirectional Rover with Printed Gearboxes

Nov 17, 2026 Last reply: 3 hours ago 3 Replies
Jump to replies (3)

The detail that caught me off guard is the drivetrain: each of the four wheels runs on a planetary gearbox and bevel gear set that are themselves 3D printed, driven by a Nema 23 stepper motor. Printed gears carrying a platform rated for 25 kg payloads is a bold claim, and I mean that as genuine praise. Most builds at this scale fall back on off-the-shelf gearboxes, so seeing the reduction stages printed alongside everything else stands out.



The chassis is a lattice of printed brackets held together by M8 threaded rods in 580, 250 and 230 mm lengths, with M8 nuts and 625 2RS bearings. Drive units are secured with M3 and M4 machine screws, and the gearboxes call for 61803 and 4x8x3 bearings. The mecanum wheels combine printed hubs, cylindrical rollers on 4x46mm pins, center M5 locknuts with M3 hardware, and decorative rims.



The electronics are tidy and specific: an ESP32 WROOM 32 board paired with a CNC Shield running four TMC2209 stepper drivers adjusted to 2.4V, cooled by a 50x50x10mm fan. Power comes from power tool battery packs wired through spade connectors to a rocker switch, with a DC-022B 5.5mm barrel jack and an LM2596 step-down converter tuned to 5V. Modular body panels mount front and rear ultrasonic distance sensors plus decorative LED strips, and side brackets hold a smartphone, modeled as a Galaxy A21, for camera streaming. The name ARCTOS is embossed on the rear panel, a nice touch.



The stated capabilities are autonomous environment mapping and SLAM navigation, with a flat top plate meant to carry payloads or a robotic arm. That arm is the open question here: the plate is designed for one, but whether an arm is actually part of the project remains unanswered. Whether the printed parts could be done in PLA is also unresolved, and worth knowing before anyone commits filament.



Project by Arctos Robotics. Watch it on their YouTube channel:

formatting link


The choice of power tool battery packs wired via spade connectors to a rocker switch seems clever to me. Spade connectors should make pack swaps quick, and a rocker switch is a simple, reliable way to cut power at the source. The trade-off is that tool packs are heavier than a dedicated pack, but easy replacement probably outweighs that for a rover meant to haul 25 kg.

Has the maker said anywhere whether the structural parts, especially the gearbox bodies and wheel hubs, could be printed in PLA instead of something tougher? The question has come up but I have not seen an answer. With printed gears taking the full drive torque under a 25 kg load, the filament choice seems like it would matter a lot.

A concrete variation I would suggest: the LED strips on the body panels are currently decorative, so giving them a job would add value without new hardware. They could indicate sensor activity from the front and rear ultrasonic modules, or simply show that the ESP32 and drivers are powered. It keeps the panels modular and turns existing parts into live feedback for debugging runs.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required