3D Printed Replica of a Space Telescope Mirror Actuator

Nov 17, 2026 Last reply: 5 hours ago 3 Replies
Jump to replies (3)

The most surprising part of this build is the lost-motion coupling: the disc spins through roughly 320 to 330 degrees before its pin finally engages the secondary drive. Nearly a full turn of free rotation, all to let a single stepper motor serve a fine stage and a coarse stage. That is a very elegant piece of mechanical sequencing, and seeing it recreated in printed parts is a treat.



The assembly mixes printed and bought hardware nicely. There is printed framing, spur gears, bevel gears, a flexible pivot bridge and a dual-disc pin coupling, alongside metal ball bearings, threaded hardware and a small stepper motor with ribbon wiring. Diagrams labelled Figure 10 Section View call out the gearmotor, the pivot flexure and the ball screw shaft, and the CAD work was done in Fusion 360.



The two stages split their jobs cleanly. For fine positioning, a camshaft drives a central flexure bearing that pulls the arms inward and flexes the top plate. For coarse movement, the coupling disc drives a 1:8 gear reduction that feeds a lead screw. A digital dial indicator measured vertical displacement of the upper flexure at values between 0.062 mm and 0.088 mm, which gives a real sense of how small the fine motion is. For context, actual JWST segments rely on hexapod actuators covering seven degrees of freedom, including tip, tilt, roll and XYZ translation.



One open point: during the intentional backlash of about one full revolution, the fine stage acts alone, and it is not yet clear whether both adjustments are active afterwards. The lead screw also disengages when the motor direction is reversed, and I would enjoy seeing how that behaves over repeated cycles. Packed lithium grease in the gears is a lovely touch for a teaching model, too.



Project by Breaking Taps. Watch it on their YouTube channel:

formatting link


The dual-disc pin coupling is the standout choice for me. Spending roughly 320 to 330 degrees of rotation on free spin before the pin catches the secondary drive is a bold trade: most of a turn does nothing, but the switch between the fine and coarse stages happens through pure geometry rather than added hardware. That seems like a very tidy solution, and the printed version makes the whole sequence easy to follow.

When the motor direction reverses and the lead screw disengages, does the coupling pin have to travel through the whole lost-motion span again, that roughly 320 to 330 degree gap, before the coarse drive picks up once more? I keep trying to picture the handoff in my head and would like to know how the sequence resets.

A printed pointer and a graduated scale on the coupling disc would be a neat addition. It would make the lost-motion span and the exact moment the pin engages visible at a glance, which would help when explaining the one-revolution backlash to anyone new to flexure mechanisms. A small window in the framing to watch the gear train through would be a bonus on top of that.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required