⚙ Mechanical Engineering

  1. Home
  2. ⚙ Mechanical Engineering
2772 Threads Posts
to

Infernal combustion question

I have a 2004 Chevy Cobalt (aka. Cavalier). When new, I was getting 30.5 mpg or so. Then about 45,000 miles the valves...
20 comments posted 18yrs
posted by dlzc1
20 comments posted 18yrs posted by dlzc1

Finite Element Analysis Benchmarks

I've heard that standards exist for verification and validation of FEA solutions. I've done some digging and all I've s...
0 comments posted 18yrs
posted by no
0 comments posted 18yrs posted by no

I need find maximal torsion moment of lower leg.

Hallo, Please I need find literature, where are informations of maximal torsial moment on lower leg. Thank you.... :)
0 comments posted 18yrs
posted by mrazekmichal
0 comments posted 18yrs posted by mrazekmichal

Instrumentation 2008 a Great Success

I hope you were able to attend. Many videos were taken at the expo - = this one is a walking tour of one section of the...
0 comments posted 18yrs
posted by info
0 comments posted 18yrs posted by info

millwright and engineer

Thank you so much,comrades! I have another question: Can millwright become an engineer?
6 comments posted 18yrs
posted by wxshdzh
6 comments posted 18yrs posted by wxshdzh

Enough compressed air for an air cannon?

Hi folks, I hope I can get some advice on a project I have to build an aircannon that can shoot a ball out using compre...
7 comments posted 18yrs
posted by spam.ontoast
7 comments posted 18yrs posted by spam.ontoast

Mechanical Engineering Positions

ABCO Automation, Inc., located in the highly desirable Piedmont Triad region of North Carolina, is seeking an experienc...
0 comments posted 18yrs
posted by dellat
0 comments posted 18yrs posted by dellat

A Roots Blower Style Air Flow Engine

The roots blower as a compressor for turbine operation requires several stages. A single stage cannot cause the correct...
2 comments posted 18yrs
posted by eaglesondouglas
2 comments posted 18yrs posted by eaglesondouglas

planetary gear ratio calculations

I have been trying to figure out what the gear ratio for a planetary gear is when the sun gear is held stationary and t...
6 comments posted 18yrs
posted by 1qazse4
6 comments posted 18yrs posted by 1qazse4

ASTM FASTENERS MANUAL

I M LOOKING FOR ASTM STANDARDS MANUAL FOR FASTENERS. I M INTO MANUFACTURING OF FASTENERS, NEED SPECIFICATION & STANDARD...
2 comments posted 18yrs
posted by aanuraj
2 comments posted 18yrs posted by aanuraj

how to find a job

I already sent a lot of resume through fax but no respose. Who can help me or give me some advice.
6 comments posted 18yrs
posted by wxshdzh
6 comments posted 18yrs posted by wxshdzh