1. Home
  2. Metallurgy discussions
  3. Looking for filler material for weld repair of CE3MN castings

Looking for filler material for weld repair of CE3MN castings

Hi All,
I am looking for a filler material for weld repair of CE3MN castings.
I need filler material that can meet ASTM A890 / 995 Grade 5A with the
following ferrite requirement 35-65% ferrite using the metalligraphic
point count method.
Thanks,
Giorlando
Reply to
dinaraman
Loading thread data ...

Site Timeline

Related

  • What Filler To Weld Grade HP alloy Castings

  • Does anyone know the best filler metal to weld grade HP Heat ResistantAlloy...

  • What Filler To Weld Grade HP alloy Castings

  • Does anyone know the best filler metal to weld grade HP Heat ResistantAlloy...

  • Corrugated repair with filler

  • A bit of an odd request for help with this one... I have a caravan which has a...

  • Weld repair of Magnesium (Possible/Practical?)

  • Hi, all!Apologies if this has been recently discussed; I'm just getting back...

  • Weld filler chemical composition

  • Of inconel and hastelloy, which would be closer to plain ol'...

  • TIG Weld Aluminum Filler Rod

  • I am seeking to purchase a small quantity (a few sticks up to onepound) of...

  • How to increase mfi of a filler master batch

  • I would like to know how to increase mfi of a filler master batch compound Base...

  • TIG Filler rod named "MG710"?

  • I have some TIG filler rod labeled MG710, 5/32" thick. This is somekind of a...

  • JB Weld vs. Araldite

  • Both glues seem to be 2-part epoxy, but is one much better than theother? I know...

  • more on welding - pic of weld

  • Oh! The halloween-welder, who doesn't want to learn to weld! :-) Not to bad!...

  • OA Filler rod for car repair

  • Which OA filler rods would you recommend for welding new panels to my trusty old...

  • Storing GTAW filler

  • Guys, I have a bunch of tubes of 36" filler rods for all sorts of different...

  • cost of castings

  • how much would you want to pay for one of...

  • Looking for material of rotor & stator of Motor(Generator)

  • Dear gentlemenI am an electronic engineer of Korea.I'm looking for best...

  • Proper Looking Tig Weld

  • Welding 304 SS with 4043 SS rod 100% argon 3/32 thoriated tungsten...

  • looking for belt material

  • I am looking to restore an old metal lathe. I cant find a source for thedrive...

  • ss316 filler for ss304

  • Would like to know if 316L filler should only be used on 316 basemetal.I have...

  • castings

  • saw this on e-bay, does anyone know the manufacturer of the castings?looks quite...

  • filler for 5052 and 6063

  • What is the best filler for welding 5052-h32 sheet 0.1" thick to 6063-t52angle...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.