1. Home
  2. ⏣ General Metalworking
  3. Big A-- fans

Big A-- fans

The place where I work just had 2 of these cieling fans installed, 24 foot
diameter. Seems to work pretty well.
formatting link

Reply to
RogerN
Loading thread data ...
Cool.
I've been thinking about replacing the ceiling fan in the master bedroom...
Reply to
darus

Further Reading

  • Cooling performance with 2 fans?

  • I've got a piece of lab test equipment that's about 30 years old. The...

  • centrifugal fans

  • In the past, I asked on sci.chem whether one could improvise a fume hoodby using...

  • Any vintage Toledo scale fans here?

  • Awl -- The old floor-standing platform scales, 24" face, usually on wheels.I...

  • Muffin Fans sources?

  • I got some Comair Rotron fans, that fit the spindle motors on some ofmy...

  • Fans in Series

  • There's metal content as this will be part of a lathe repower project.If one...

  • For the benefit of Airfix fans...

  • Strange looking beast, the Nimrod.Especially with the big nose and tail...

  • Neville Shute Fans

  • Any modelers out there who like Neville Shute's books should checkout Amazon...

  • Neville Shute Fans

  • Any metal workers out there who like Neville Shute's books shouldcheck out...

  • Brisbane Lego Fans

  • Anyone who is interested in buying directly from Lego as a group to save onthe...

  • Any Henrob fans?

  • I picked up an unused Henrob Dillon Mk 3 very cheap with a lot of other stuff. ...

  • A little something for NASCAR fans....or fans of surfacing in SolidWorks

  • Hello All,I just thought I would post some images of a little SolidWorks...

  • for fans of chris brown

  • In article , snipped-for-privacy@gmail.com writesNo. I was worried enough...

  • Noisy small equipment fans

  • I have a couple of devices with very noisy and annoying fans. One isan old...

  • Clausing 5900 Series Lathe Model ID Chart

  • (Info provided by Mike Henry) Clausing 5900 Series Model Identification Chart...
  • « previous thread

  • What is it? LXXVII

  • A new set of photos has been posted: Rob What is it? #443: Hammer for body work,...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.