1. Home
  2. ⏣ General Metalworking
  3. DRO Calipers for Lathe or Mill

DRO Calipers for Lathe or Mill

Anyone from using DRO's (calipers) on their lathe or mill?

Like the ones from

formatting link
If so where you get it from and what was the cost?

What's the quality like?

Based on the above link is the DRO and the digital display units good value for money?

Or is there a better or cheaper way?

thanks DazFNQ

Reply to
DazFNQ
Loading thread data ...

I use this one on my Clausing lathe on the cross slide:

formatting link
I totally love it.

I bought it from Shars.com. Mine is a 8" version. Approximately 30 bucks. It is horizontal, and a vertical model would suit me better, but I already had it as a leftover from another project.

i

formatting link

Reply to
Ignoramus22807

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.