ETM ER-20 Collet Chuck

Does anyone know what spindle threads the ETM ER-20 Collet Chuck Part#

4501928 has.

I measured them and they look to be just about 25mm. I wanted to make a couple of holders that screw onto the spindle. But I don't know what tap I should get. I could only find 24mm and 26mm taps.

I'm not sure if they are a standard thread. If anyone has any info on the diameter and pitch of this thread, that would be great.

Thanks.

Reply to
Terry
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.