The wife's dog is out of control. Yesterday I went to the truck to get a Sharpie and back to the shop and the tool I was just using was gone. So I start searching beating my head against the walls tring to figure out where I might have set it. It should have been right in the open ! A little voice says its the dog and its out in the yard , but that can't be cause it should have been in the middle of the work bench. Yep, in the yard... The dog must be standing up and grabbing stuff , it must be watching what I'm doing even though it looks half dead laying infront of the swap cooler.
It just happened again and this time took my only small dial indicator and I found it all slobbered and in the durt ! I'm in the middle of making a holder for it and was hoping to get it done and set up for the next step of the job. Now I don't know what to do to clean it. I'm afraid to touch it. Soft brush and then ahhh hold it the best way in gas and then compressed air and hope for the best ?
Help , an answer soon would help. I have to go back to work tomorrow and wanted to get farther on this project than at a dead stop.