How do you use this thing (engraver bit)

Sep 01, 2007 1 Replies
W

How do you properly use an engraving bit? I bought the RCS-125-2

formatting link
I'm assuming you spin them pretty fast since the effective cutter diameter is just about nil, depth of cut isn't going to be much since it is engraving. I sure don't want my first attempt to start with a SNAP.



Wes



Vote
Twitter Facebook LinkedIn
K

I'm sure material makes all the difference. We (the kid programmed) did about 500 custom stainless steel belt buckles. Started out real high on RPM and found better tool life at something like 1750 with oil. Tool life was a bitch on this one, went to using bits ground on the deckle one flute grinder and just put in a new tool after every ten batch (ten buckles clamped down at a time)

Karl

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required