Making four small tables for the packing line today...
I'm using 304 SS. The stock looks pretty clean but I'm sure I'll have some weld burns and scratches by the time I'm done.
what the best way to end up with a perfect polish on the table top?
Karl
Karl, There are a lot of items available for polishing and finishing stainless steel as well as other materials. The cheapest and best way would be to buy a kit as an attachment to an angle grinder that gives you a disc attachment with polishing discs that can be attached. The discs go from a rough finish to a smooth finish and included is the polish used for finishing. I am in the UK so I don't know what part of the world you are in but I guarantee, the same product will be available somewhere near you. The one I am speaking of cost me about =A310-00. I hope this helps. Best regards, Anthony.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.