Repeatability - Kwik 200

Repeatability - Kwik 200
Those of you who use Kwik 200 (or other Kwik too holders): How repeatable have you found the tool height to be?
I always just lowered the table on the KMB1, swapped the tool, and raised it to zero a tool height setter after a tool change. The last several months I've been using a Tormach with TTS tools and a power draw bar. I've gotten really spoiled after entering all the tools in the tool table. For a tool change I just swap the tool and press start. That's it. They repeat within a few tenths. Better actually than the machine itself. I recently purchased an ISO20 spindle for one of my high speed machines, and if it works out I'll purchase them for the others as well. I'm about to get the Hurco KMB1 back in service, and I was wondering (can't check at the moment) how repeatable the tool height was with Kwik 200 tool holders.
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload

Polytechforum.com is a website by engineers for engineers. It is not affiliated with any of manufacturers or vendors discussed here. All logos and trade names are the property of their respective owners.