Tapmatic Tool Changer 80-381 Help Needed

I have a Tool Changer, Model 80-381, that was made by Tapmatic, Costa Mesa, CA. It is also marked JAHRL, Orebro, Sweden. It has an R-8 shank and the head is a quick change for collets which thread into tool head and are held by ball detent and centered with a taper. The 1/2" end mill holder is marked JAHRL 80-381-H1/2" . The short collet holder is marked JAHRL 80-381-CH 10. Anyone know if these are still supported or have any information about this tool system?

Reply to
Donald A. Rothfuss
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.