Will do. Might finally have something worth adding to the DropBox....
Jon
The Cole Drill gloat
May 17, 2009
44 Replies
One aspect that looked a bit odd at first, was that the pressure screw is fabricated from 2 separate pieces. The top hex section appears to have been pressed or shrink fitted to the threaded round section.
The thrust bearing I have is the shielded, integrated ball bearing type such as McMaster 60715K12 (if this link doesn't go directly to it)
formatting link
Thanks. That certainly explains why the ratchet isn't reversible, anyway. --Glenn
It sure would. Everyone in the Federation knows that 'Setting a Phaser to maximum' causes it to explode, in a few seconds. You must be a Klingon infiltrator!
In Lautard's 3rd Beside Reader there is mention of the drill adapter being "three sided". Perhaps there are three screws to attach any size drill to the Cole drill?
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required