Are there any off the shelf metal brackets which are course threaded and accept a 1/2" threaded rod? These would be used to guide the rod down an inside corner of a worktable to a stemless caster. The threaded bolt replaces the stem, and with the bracket, will raise and loser the caster. However, I am trying NOT to have something custom made. Any suggestions?
threaded bracket help needed
Aug 30, 2003
1 Replies
Couple of questions - Is the table metal that you may be able to buy 1/2" allthread, run a couple of nuts up on it at the appropriate spacing and simply tack weld the nuts to the inside corner of the metal leg? Are you just looking for a vertically adjustable caster, or do you want to be able to pull the caster up far enough that the table legs rest on the floor? Ken.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required