⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30748 Threads Posts
to

Skil model 732 RotoHammer

Does anybody have a clue where to get information and/or parts for a Skil model 732 RotoHammer? It uses a 3/4" hex shan...
4 comments posted 9mos
posted by bp
4 comments posted 9mos posted by bp

Yaaaaarrrrd Salin'

My $5 12" bench top planer I got today works ! One of the blades is damaged and I need to fabricate a guard over the cu...
2 comments posted 9mos
posted by Snag_one
2 comments posted 9mos posted by Snag_one

Stuck Rings Maybe

Good Soak For Rings In an Engine That's Been Sitting A Long Time??? When I was a kid everybody said to dump a table spo...
43 comments posted 10mos
posted by none
43 comments posted 10mos posted by none

Another project gift

I'm not sure if I mentioned this in another post ... My neighbor had this tractor mount post hole digger . Now it's min...
4 comments posted 10mos
posted by Snag_one
4 comments posted 10mos posted by Snag_one

Overlooking the Obvious

When I can make a mold that I think will sell more than one I like to find or make a fixture plate that will allow me t...
0 comments posted 10mos
posted by none
0 comments posted 10mos posted by none

Oil Vs Water (Manual Machining Headache)

I typically apply cutting oil by hand, and water soluble by a flood blast from a pump. (more or less) Whenever I see a...
3 comments posted 10mos
posted by none
3 comments posted 10mos posted by none

Have to Move the "Big" Lathe

I had an email this morning from a customer asking for a semi custom variation of a stock design mold so I headed out t...
10 comments posted 10mos
posted by none
10 comments posted 10mos posted by none

Stuff

I've been putting extra stuff up for sale on line. Bauer SDS MAX rotary hammer from my dad's stuff sold for a fair pric...
4 comments posted 10mos
posted by none
4 comments posted 10mos posted by none

Hello??

Is R.C.M. working and everyone OK?
67 comments posted 10mos
posted by muratlanne
67 comments posted 10mos posted by muratlanne

HEY LES! Egypt 2027?

Have you booked passage yet? The earlier you book the cheaper it will be. Also probably the best chance in that region f...
6 comments posted 10mos
posted by none
6 comments posted 10mos posted by none

Just a Stupid Box

I've got a decent hydraulic port-a-power type kit. Rams, extensions, hand pump, etc. It works, but I keep it in the box...
10 comments posted 11mos
posted by none
10 comments posted 11mos posted by none

It Wasn't Me - Again - TIG Welding

Some of you might recall my years long failure to learn to MIG weld. I could get things to come out okay with aluminum...
1 comments posted 11mos
posted by none
1 comments posted 11mos posted by none

Prosthetics And The Prison Camp Lathe

Hi, Hackaday recently ran this article which I found interesting. I'm sure there a few of you that already know this ol...
1 comments posted 11mos
posted by lfiskgr
1 comments posted 11mos posted by lfiskgr