Anyone got a 2 BA left hand threaded machine screw?

Aargh! Yesterday I made a real mess of a screw trying to remove it because I didn't realise it was left hand threaded. One of those times when a manual would have been really useful. Does anyone have a 2 BA left hand threaded machine screw, or know of a source? The original is tin plated brass with a cheese head and 7/16" long, but these details aren't critical. Let me know if you do!

Many thanks,

Chris

Reply to
Christopher Tidy
Loading thread data ...

In article , Christopher Tidy writes

You have e-mail...

Reply to
Bob Unitt

Hi Bob,

Sorry I haven't responded to your e-mail. I didn't receive it. Perhaps it went astray or perhaps you didn't notice the spam block in my e-mail address? I apologise for the spam block but it was the only way I could find to reduce the amount I spam I was receiving. I was getting several times as much spam as good messages a year or so ago.

Please post your message to the group or e-mail me at (no spam trap this time, one more occurrence can't hurt): snipped-for-privacy@cantabgold.net.

Many thanks,

Chris

Reply to
Christopher Tidy

Hi Chris,

You're right, I didn't spot your spam-trap :-(

I've re-sent the e-mail to the above address, so it should get through OK this time - if it doesn't, post again here and we'll try something else.

Don't try e-mailing the address in this posting by the way, as it's also a spam-trap...

Reply to
Bob Unitt

Thanks Bob. Got your e-mail. Just sent a reply...

Best wishes,

Chris

Reply to
Christopher Tidy

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.