any suggestions for controllers I would like to use my division master with it if possible
mainly for engraving
Thanks Andrew
any suggestions for controllers I would like to use my division master with it if possible
mainly for engraving
Thanks Andrew
The two that spring to mind are TurboCNC and Mach2 (Demo version) o
Mach3 if you pay for it. You can get both for free as demos.
TurboCNC uses DOS, Mach uses Windows but cannot be used for anythin but Mach when you do.
Try
Try
Regards Robi
-- rss
----------------------------------------------------------------------- rsss's Profile:
Have a look here
Stephen.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.