group order: 40mm,18slot statorlaminations

Ron van Sommeren 21 anni fa

Goedendag ;-)

Ralph Okon (a.k.a.

formatting link

is putting together a group order for

40mm. diameter, 18pole statorlaminations (e.g. for direct drive helicopter motors, large props). A minimum order of 5000 laminations is needed to start a production run. Minimum order per person is 50. One 0.20mm lamination (NO20 iron quality) will cost 0.5?. Flux ring and frontplates will probably also be available by then. Keep in mind, this is not a business for Ralph, he's in the business of curing people :-)

More info on ordering;

formatting link

More Italian do-it-yourself motor discussion:

formatting link

I'll post this in several lists/forums, think it's best if we all discussed/asked in the first thread above.

Vriendelijke groeten ;-) Ron van Sommeren near Nijmegen, the Netherlands

Vote

Ron van Sommeren 21 anni fa

Goedendag ;-)

... More info from Ralp Okon ...

I think, you should better calculate with ca. 4 per mm, because of the needed insulation between the plates. in summery 40 up to 45 per cm I think.

we are looking now for curved magnets for the project. it seems, if there are enough users who join the project, ist could give a complete set (can, bearings, etc.) for the motor. lenght then 5, 10 and 15mm in first attempt.

and the baby has a name now: its our "CROCODILE"

-has many teeth too, more then the others :D

-seems to be leazy, but is a very powerfull animal.

- there are big elektrical lokomotives(?) for railway, also named so:

formatting link

if you are interested in more details, please have a look at

formatting link

we have orders for 2000 statorplates now and we need minimum 5000 to get this very good price.....

viele grüsse, ralph

formatting link

--------------------------------

Vote

Ron van Sommeren 21 anni fa

Turned parts, magnets, shafts, ball bearings will become available too. Drawing:

formatting link

More info

formatting link

Deutsch

formatting link

Remember, this is not a commercial thing, it's a group design project from the diy motor builders at

formatting link

Vriendelijke groeten ;-) Ron van Sommeren near Nijmegen, the Netherlands

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required