Injection moulding - plasticising time

- R
- rocketrod63
  
  Contact options for registered users
posted
18 years ago

Tue, Aug 10, 2004 9:11 AM

What does the plasticising time do in an injection moulding cycle and if you
were to very it what would be the effect on the finished product/injection
cycle,
Thanks,
Rodney.

Loading thread data ...

- A
- a.fahad111
  
  Contact options for registered users
posted
7 years ago

Tue, Dec 2, 2014 5:47 AM

?????? ?????? ??? 10 ?????? 2004 UTC+3 12:11 :46 ?? ??? rocketrod63:

In plasticising time, mixing of the material happens. So, the longer it is the better mixing you will have. But, you need to make sure that it is not very long so that the material undergoes degradation.

Injection moulding - plasticising time

Further Reading

injection moulding

Injection moulding

Injection Moulding

injection moulding discussion group

Re: Reg-Injection moulding

Small questions about injection moulding practice

plastic injection moulding - 'Model Railway News' article (Ancient!)

Research concerning injection moulding companies who fabricate TPE products

Making injection pump spindles?

Thermoformable or injection moulding for high T resistant polymer ?

PH1 Injection Timing.

Diesel injection pump pressure test ?

Lister CS Injection pump problems

AISI 1050 Steel for Injection Molding

Validation of moulding maschine

Need material that's like linoleum without twine backing

need information about Rika Lite ®