PEEK flow-cell

Hi, my question is: whether a PEEK flow-cell has to be fabricated with 'usual' machining techniques (like drilling, milling, cutting) or with rapid prototyping (stereo lithography). Thank you very much in advance, Andrea

Reply to
andrea_gazze
Loading thread data ...

For what? PEEK machines fine, but it's relatively hard to get machined plastic surfaces perfectly clean.

So if you're measuring water turbidity, machining is the way to go, but if you're monitoring ultrapure water, you'll need to work a bit harder.

Cheers,

Phil Hobbs

Reply to
Phil Hobbs

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.