Gurus:
Tried to change the color of a skeleton surface and it didn't seem to want to change.
Is this because:
A. The file is read only
or
B: You can't change the color of a skeleton surface in the skeleton model?
Thanks
Mike
Mike, "A" is the cause. Since the file is "Read Only" any changes yo make are only temporary. Are you doing this at the assembly o skeleton level? You can change the color/appearance of the skeleto from the assembly level
Are you using WF2, WF or 2001?
Hope this helps, Glenn |B
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.