Radial pattern of rectangles - creation using ProWidfire 2.0

To any expert...
When a hole extrusion is placed on a surface, it is easy to create a radial
pattern because references become polar.
When a rectangular extrusion is placed on a surface it gets cartesian
coords, and patterns are assumed to be of a square array type.
How can a radial pattern of rectangles be produced?
Thanks
from Peter Watt
Reply to
News
Loading thread data ...
Datum on the fly should do fine. (Through axis, Angle) Just make sure all dimensions and contrains are referenced to "on the fly Datum" and Axis for radial pattern.
C.Pham
Reply to
Chinh Pham

Site Timeline

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.