1. Home
  2. PRO/Engineer (Creo) discussions
  3. Start exe file from WF20

Start exe file from WF20

Loading thread data ...
Hey Frodo,
This is possible. I have seen it done but I never tried it personally. The key is using mapkeys. Check this link for instructions:
formatting link
Hope this helps.
-Adam Joseph Cook, Mechanical Engineer
Reply to
Adam Joseph Cook

Site Timeline

Related

  • Is it possible for a macro to setup a button on a toolbar?

  • Is it possible to write a macro that will create a button on anexisting toolbar,...

  • toolbar button macro

  • In acad2007:If I type this at the command line:(startapp "c:\program...

  • EXE surface grinder

  • Hello Oliver. I have an exe grinder which I am doing up. Unfortunately it...

  • Where to put valve limit switches

  • I am doing an automation upgrade to a steam superheater at our gasplant. ...

  • Possible to create a custom toolbar in SW?

  • I would like to create a custom toolbar called "Engineering Macros".If read that...

  • Added a start/stop button to compressor

  • Finally, I have my compressor wired exactly as I wanted. The last piece that I...

  • How to put wheels (landing gear) on balsa Spitfire?

  • How do I attach the wheels and landing gear on a Guillow balsa Spitfire model....

  • possible to replace the gas engine on old welder?

  • The old welder/generator I picked up today doesn't look too bad if you sort...

  • Possible to bend conduit into circle?

  • I sometimes use conduit to make yard ornaments to put lights aroundfor...

  • Is it possible to....

  • Hey,Quick question or at least I think it will be. What I am going for is tohave...

  • Possible to turn HSS with HSS tools ?

  • Hi, I read that it is possible to turn HSS with HSS tools but it seems hard to ...

  • Control the toolbar button (Enable or Disable)

  • Hi all!!!Someone can help me with toolbar? My problem is when i want to enableor...

  • Is it possible to run a macro file from another macro file?

  • I have a macro that I would like to run at the end of a macro. Theseare (2)...

  • Help !!! power start button on birmingham Lathe

  • I just bought a Birmingham 12x36 gearhead lathe. Installed a 220v outlet inthe...

  • .tst file and a mapkey....WF

  • If someone could run the (Verify Instance) in the family table...

  • Possible to shrink expanded O-rings

  • Hi,I have four tiny but very expensive O-rings used for dust scrapingaround...

  • Flywheel teeth repair on tiller possible?

  • My dad has an older Troy Bilt tiller with electric start. It just sitsand spins...

  • rifling button pusher

  • block. Then two > barrels clamped and held straight. Top one is just scrap for...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.