1. Home
  2. Model rockets forum
  3. Lockwood pulsejet

Lockwood pulsejet

i am building a pulsejet and i wanted to know what the formula was to
calculate the amount of speed an object would go based on its wight
and the thrust of the engine.
thanks
trashman
Reply to
Trashmaster2000
Loading thread data ...
This should get you started:
formatting link

Reply to
BB

Further Reading

  • The Enthusiast's Guide to Pulsejet Engines

  • Does anyone have the "pulsejets for rc planes" -part of the book...

  • Am I a fool to buy this mill/drill?

  • Need some advice, here...I occasionally wish I had a small mill, but can't...

  • WHAT AM I MISSING!

  • I seriously want to get all of my stuff out of boxes and set up a layout but I...

  • Lying to my wife

  • I am so tired of hearing all this too, I must confess. It makes me not want...

  • Am I nuts or what?

  • so for the past month I've been trying to sell off lots of my modelsbecause...

  • Am I stupid or what ????

  • Hi,I am new to 3d cad after may years of AutoCAD.....I have a drawing of a plate...

  • I know FLA & LRA but what is RES (on contactor label)

  • I've got some contactors that show Full Load Amps and Locked Rotor Amp...

  • Problem with a model I am building

  • Hi all,I am trying to build the Lady Stephanie beam engine, Vol 3 page 211...

  • PIPING - what am I missing?

  • I am new in this area of design and I expiriencing some difficulties that I...

  • I am building all my kits NOW!!!!!!!!!!!

  • In light of the fact that Osama has the green light to Nuke the US, Iam saying...

  • What am I doing wrong?

  • I have not had a lot of luck cutting thin plate without a lot of slag and...

  • I don't know what I want to be when I grow up...

  • Peeps - I'm looking for a job. I have an engineering degree and 5 years...

  • Am I as smart as a SA 200?

  • Another SA 200 welding machine came up yesterday. I am going to go look atit...

  • What am I doing wrong?

  • Hi Everyone,Im an api newbie please add your advice if you can.What is wrong...

  • I am happy to report.......

  • That I am happy. I tried my first welding of aluminum today.Setup: Millermatic...

  • [PR] railbuttons.com

  • Just two quick notes: 1) Entries for the December giveaway are now being...
  • « previous thread

  • Re: BATFE Director Buckles resigning to enter private $ector

  • So was he an instigator of the madness, or merely a figurehead for...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.