Has any one had any luck bringing in a file from 3d max 6 to SolidWorks. Have not had any luck with the .stl export.
3d Max to solidworks
Jun 25, 2004
2 Replies
Try bringing it into Rhino3D, and from there into SolidWorks.
Mark 'Sporky' Stapleton Charlotte, NC
formatting link
It would only fail if the STL is not valid, that is, it's not a closed (water tight) volume. So, there maybe a open seam or a facet failed to close? I'm not sure if Max has repair or check tools but maybe if you reimport the STL file you could check it?
..
Bryan Solace wrote:
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required