Hi all, I want to know how to increase out put of eps cups production. At present we have 8 cavity cup mold and have 7 machines at the rate of six cycle per minute we r producing only 200K pieces only . it is very low out put . i want to improve this production up to 600k please suggest me thank you raj
I don't believe this is the correct forum for this discussion. Nor do I think you'd like my answer to your question (namely that this kind of information usually requires an expert which would be paid for his/ her services). However, you may wish to provide more information if you want assistance from these forums.
Matt Lorono
Seven machines times 8 cavities times 6 cycles per minutes should give you (assuming 100% yield for now) 336 parts per minute. That gives you 20,160 parts per hour. Are you only running 10 hours a day to give you 200K parts per day? If that is the case, you can run more hours per day to increase your output to over 400K parts per day. If you can't increase the time you run, then you either have to add machines, put more cavities on each machine, reduce your cycle time, reduce your scrap rate, or some combination of the above.
Jerry Steiger Tripod Data Systems "take the garbage out, dear"
What are you using for feedstock and what temperatures are you running the mold at? What testing have you done with machine timing and temperatures?
TOP
Outsource to china or india and get lots of cut-rate slave laborers to manually do it for you.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.