Anyone know the id hole size of a OLFA 28mm rotary blade?

- B
- Ben
  
  Contact options for registered users
posted
18 years ago

Thu, May 12, 2005 3:32 PM

Anyone know the id hole size of a OLFA 28mm rotary blade? Figured someone might know or have one in their desk that they can pull out and measure. TIA

Ben

Loading thread data ...

- S
- SMacIntyre
  
  Contact options for registered users
Vote on answer
posted
18 years ago

Thu, May 12, 2005 5:18 PM

Don't have one, but click the following link and then on the "35008" p/n link. It looks like it'll give you a drawing that maybe you can scale...Don't know how accurate you need....

formatting link

Scott

- B
- Ben
  
  Contact options for registered users
Vote on answer
posted
18 years ago

Thu, May 12, 2005 9:15 PM

Close enough, sure it is a standard size so I will scale the JPG in SW and trace...

Thanks

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.