The Solidworks Bend Allowance table is set for 90 degrees only, how can I automate it to be used in a 0.25 or less increment angle up from .5 thru 359.5 degrees, also I like to use all different thickness steel plates...
Thanks for any help.
The Solidworks Bend Allowance table is set for 90 degrees only, how can I automate it to be used in a 0.25 or less increment angle up from .5 thru 359.5 degrees, also I like to use all different thickness steel plates...
Thanks for any help.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required