Hi Is there a way to make a comestic thread in modeling to a round shaft and also a hole that was cut with just a sketch? Thank You
- posted
18 years ago
Hi Is there a way to make a comestic thread in modeling to a round shaft and also a hole that was cut with just a sketch? Thank You
Yes there is. For the hole, just click on an edge and then Insert-annotations-cosmetic thread and then enter the pertinient information. It's probably similar for the shaft, but I haven't done it myself.
Good Luck.
jk
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.