Hi everyone, Have any of you had any success welding on an engine block? The engine is a Perkins diesel in a Hyster forklift. The crack is in the cooling jacket of the block. Thanks, Shawn
read more »
Hi, Does anyone have a Dremel multitool, and could they tell me the length/diameter/pitch of the spindle thread? It may be imperial as these things are American, and around 7mm/0.275" dia. Reason is,...
I want to recharge the refrigerant in my auto air conditioner. I've assembled all the necessary tools except for one item. My vacuum pump is outfitted with a 3/4" female NPT fitting and the discharge...
I am trying to use a linear pattern to create a line of caps, as long as they are touching it creates the objects correctly. But I am trying to have them 3/4" apart and it gives an error that "Some...
I'm doing some work in an older factory - MANY electricians have had their hands in this place. They called me today with a problem: They have a piece of equipment they have been moving from room to...
I need to slightly thin some 30 minute epoxy to make glassing a wing center section easier. I know that the high water content of isopropyl tends to weaken the epoxy, so which would be best? Denatured...
I've got an automatic chicken waterer (made by Little Giant) that uses what looks to be a truck valve stem and a common automotive Schrader valve. It froze again and broke a fitting and I have tried...
Ive located a quantity of Hardinge 4c collets. Probably about 200 or so, various sizes. Any interest in them singly or in sets? Gunner "Gun Control, the theory that a 110lb grandmother should fist...
Hi folks, I bought this really cool 3M tape dispenser recently. It's cast iron and weighs a ton: the blade's a little blunt and I can't find anyone who supplies replacements. It's not incredibly blunt...
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.