Fixing a squeaky rear driveshaft joint on a Samurai

Nov 18, 2026 Last reply: 3 hours ago 4 Replies
Jump to replies (4)

When this repair is done right, the truck goes back to running quietly, and that is exactly the outcome here. A squeak that appeared after an overland trip, one that changed with speed and throttle, was traced to the universal joint on the rear driveshaft of a Suzuki Samurai. Once the new joint was in, the maker confirmed on a test drive that both the squeaks and the vibrations had stopped.



Getting there took a proper teardown. The driveshaft came off the transfer case flange and the rear axle pinion flange, undone with a battery-powered ratchet and a combination wrench. The old joint was a KOYO non-greasable unit, and it was in rough shape: excessive play, signs of overheating, and needle bearings that had disintegrated. A Moog U-joint went in as the replacement. The bearing cups were pressed out with a hydraulic shop press and sockets, with a ball-peen hammer assisting, and the new joint was driven in using deep-well sockets before snap-ring pliers secured the retaining clips. The external C-clips themselves came off with snap-ring pliers and a pocket multitool.



One detail stands out to me: the two-piece driveshaft was reassembled with the slip yoke splines phased to keep the end yokes in line, and phasing them that way prevents driveline vibration. That is the kind of step that is easy to skip and easy to regret later.



It was not all smooth pressing, either. One side bound up during the process and had to be straightened with an oxy-acetylene torch, work that happened off-camera. The in-cabin test drive confirmed the fix, and the cabin carries a dashboard, aftermarket gauges and a Yaesu handheld radio mount, which makes for a satisfying finish.



Project by Matt Verley. Watch it on their YouTube channel:

formatting link


Curious about the replacement itself: did the maker go with a greasable Moog joint or a sealed one? The original KOYO was non-greasable, so I wonder whether staying sealed was the plan or whether greaseability played into picking the new kit at all.

Phasing the slip yoke splines on a two-piece shaft strikes me as the smartest bit here. It would be simple to bolt everything back together one spline off and then chase a mystery vibration for months. Taking the extra minute to line the end yokes up is cheap insurance.

For a next attempt, I would try a dedicated U-joint press kit instead of the hammer and deep-well socket method. A proper press pushes the cup out straight and evenly, which could spare the kind of side binding that needed the torch treatment this time around.

The maker has not said whether the Moog joints are greasable or sealed. What is known is that the worn original was a KOYO non-greasable unit and that Moog U-joints were used for the replacement, with no mention of grease fittings either way.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required