The idea behind this project is a simple one: a worn universal joint on an agricultural PTO drive shaft does not need to mean scrapping the whole shaft, and Handmade Extreme sets out to replace the joint properly. Better still, the maker folds in tips and workarounds for the moments when the job refuses to go to plan, which is where this one really earns its keep.
The process starts with the four external circlips, removed with a center punch, hammer and circlip pliers to free the bearing cups. A 20-ton hydraulic press marked YK20F then pushed the seized cross and cups out, working over a hollow bronze support ring. On the first yoke, adjustable pliers pulled the extruded cup free before the cross was driven through. The second yoke was damaged, and its broken needle rollers had to be picked out with a thin rod before any pressing could happen.
The details that stand out are the ones many people would skip. The bores and circlip grooves got a full cleanup with a screwdriver pick, a degreasing bath, a round hand file, a cordless drill with a wire cup wheel and abrasive wool. Ear spacing was then verified with a tubular gauge labeled 92 and temporary circlips, with a small screw jack on hand to spread deformed yoke ears if needed. Grease went into the bores before the new cross, which is marked 'Made in Italy', was fitted, and reassembly happened in a bench vise with sockets and a hammer, tapping the joint to relieve binding.
The open question is that damaged second yoke. The maker cleaned out the broken rollers and pressed on regardless, but whether that yoke bore is still true after the damage is something the repair leaves you wondering about.
Project by Handmade Extreme. Watch it on their YouTube channel: