Does anyone know how to adjust the time it takes to go from weld speed to idle? Mine takes about 20 seconds and I'd like it to wait about a minute until it goes back to idle. Is this easily adjustable? The machine is a Miller Bobcat 250D NT.
Thanks, Shawn
The timing is controlled by an electronic circuit board. It is PC-1, Idle Board in the schematic at the below link. If the board is made from discrete parts, it could be possible to change the timing if you were willing to experiment with it. I would offer a guess that the addition of a capacitor of the correct value would do it.
See:
Have something to add? Share your thoughts — no account required.
Ask the community — no account required