How to reverse the weld-pak 3200 drive roller

I haven't used this model but our modern big lincoln feeders are easy. Once you release the rolls from the tension they pull off the shafts. There is a detent on the shaft and simply pull off with a firm grip. No pliers or tools required. Older feeders had allen screws that secured the roll. Randy

I'll give her a shot with a little tug. Thanks.

Ya no dice... There's no way it should be as hard to pull off as it is.... even gave 'er a good wiggle'in.

Any other ideas?

Check back with rec.crafts.metalworking. I just posted a reply there that should help.

Best Regards, Keith Marshall snipped-for-privacy@progressivelogic.com

"I'm not grown up enough to be so old!"

I am sure it is the as my (ex) Lincoln Pro mig 135. in that case , open up the tensioner, turn the wire speed know to its slowest settnig, pull the trigger on your welding gun, and watch the bottom feed roller close ly.

you will see a resessed allen head set screw , when the set screw facing upword use the supplied alen wench to loosen the drive roller and flip it over. align with the wire and retighten

good luck