move over tubemiter and winmiter ..

Here is another piece of software which prints templates for use in joining pipes at different angles, can be different sizes and can have an offset, and can be sized in inches:

formatting link
No software to load, it's a server-side application.

Looks like the guy did a good job on this software, although to be honest I haven't tried it yet.

Grant

Reply to
Grant Erwin
Loading thread data ...

Here's another one:

It uses hack saw, bandsaw or chopsaw cuts to get the miter. The program calculates the angles required.

Pete

Reply to
Pete Snell

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.