I can buy a used LTEC PCM-750I plasma cutter for about $500.00, used it and it worked well. Looking at past posts LTEC is now ESAB and they sound like bad news! Does this also apply to LTEC? Anyone have any information, good or bad about this plasma cutter?
Thanks to all of you for all of the wonderful information I have found in this group.
Clark
Some LTEC/ESAB stuff works fine. Their plasma cutters have always been OK, but their torches are a bit hard on tips.
If the machine cuts well, it should be OK, but make sure you can still get the electrodes and cups.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.