how do you pull out a cylinder sleeve out with out backing anything
i have a .o.s .20 and the cylinder needs to come ou
-- kurtlasle
----------------------------------------------------------------------- kurtlasley's Profile:
Usually you can use a popsicle stick in the exhaust port and lever it up a bit with the piston. Then a small screw driver will finish the job. If the engine is old and has been run a lot, there is probably a lot of gummed oil between the liner and casting. In this case, heat it in an oven at 250 degrees F for about 20 minutes and it might come out easier.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required