Wireless colour tv camera ride your model.

Tiny wireless colour tv cameras.

formatting link
World wide delievery. Pal or Ntsc.

Reply to
Cranbrook-hill specialist cameras
Loading thread data ...

Cranbrook-hill,

OK, so it lists several cameras there. What else is needed to transmit the video feed to, what, a base receiver I'd guess?

What frequencies?

Some on-site info on how it is supposed to work, and anything else required to make it work, would be helpful.

Reply to
Jim Lilly

formatting link
wireless color tv systems. Trust me. I have tried most of the systems available out there and his are the best.

Reply to
Fubar of The HillPeople

Hows your Spylinker system doing??? I'm finally getting mine installed in a Sky Scooter.

David

Reply to
David AMA40795 / KC5UH

Actually, I havent used the Spylinker setup for a while. I got one of the 5v

200mw 2.4ghz systems from BlackwidowAV and it rocks. Did a temporary type mounting on top of my US60 looking towards the tail. I am also using a circular polarized patch antenna and there is no signal dropout that I can see. Had a slight bit of hash when flying directly over the antenna but that is to be expected. I have no idea what the range is but it is farther than I am willing to let my plane get. Videos can be found at:
formatting link
res but faster loading:
formatting link
Reply to
Fubar of The HillPeople

The reciever can also be powered by a pp9 battery and as is says on the site the output is via an rca av out. 1v PP THIS FEEDS THE AV INPUT OF A TELEVISION, LAPTOP WITH CAPTURE CARD , PORTABLE LCD MONITOR OR IS IN MOST CASES THE AV INPUT FOUND ON A LOT OF CAMCORDERS. THE FREQ ARE 1.2GHZ OR 2.4GHZ. THE RECEICEVER COMES WITH THE CAMERA.

Reply to
Cranbrook-hill specialist cameras

How often do people run into those boulders by the pits ????

David

Reply to
David AMA40795 / KC5UH

Anyone have any idea as to the range of these things?

Reply to
Joe D

Reply to
Paul McIntosh
1.2G and 2.4G are the BANDS they run on. what frequency ranges do they run on. 1270? 1250? higher? lower? More specificaly, do they broadcast in the amatuer radio band and do they run in the allocation for video?
Reply to
tater schuld

Well, there is one movie on my website where I smacked the hell outta one during the maiden flight of my WM P47. Radio failure. Plane was repairable. Engine needed a new muffler and it turned out later that it needed a new case. It also needs new bearings due to some dummy forcing them into the new case. One hell of a smack can be heard when it hits.

Reply to
Fubar of The HillPeople

The 200mw BlackwidowAV system I have has more range than I am willing to fly. The all-in-one type systems have about as much range as you can toss a dry sponge in my experience.

Reply to
Fubar of The HillPeople

Reply to
jim breeeyar

I have three: one is 5 miles, one is 1.5 miles and one at 900 feet. Range depends on how much you are willing to pay for it.

Dan Thompson (AMA 32873, EAA 60974, WB4GUK, GROL) remove POST in address for email

Reply to
Dan Thompson

Show me a camcorder that my Hitec Sky Skooter will carry ! That's the popularity of the video via RF - the camera, transmitter and 9V battery for power weigh about 3oz.

David

Reply to
David AMA40795 / KC5UH

Yep, shore can......

I have a set of eyeglasses that has a TV screen over my right eye. It has a prism that allows focus and placement of the picture. The image is the equivalent of an 80 inch TV at 15 feet, so said the manufacturer. I can look at the plane through the glasses and see through the camera in the plane at the same time. I am right eye dominent and this causes the two images to be super imposed on each other.

I also have a set of i-glasses that I have not used yet. They have a screen in both eyes.

Dan Thompson (AMA 32873, EAA 60974, WB4GUK, GROL) remove POST in address for email

Reply to
Dan Thompson

Do you have a link to a source for these gadgets?

Reply to
David Hopper

The set I use were discontinued by the manufacturer about 4 years ago. The double set are called i-glasses and I believe wirelessvideocameras.com handle them. IIRC they were made in Austraila and production was stopped for a while. The set I have has the optional head motion sensor unit that determines roll, pith and yaw of the head. I want to use that to interface to my transmitter to automatically pan and tilt the camera in the plane. Two of my planes have pan and tilt controlled via the transmitter. The sensor for the i-glasses are no longer made.

If you want something to go down in price or go off the market, just let me buy one.

Dan Thompson (AMA 32873, EAA 60974, WB4GUK, GROL) remove POST in address for email

Reply to
Dan Thompson

Cool! Must be a challange to get used to. One eye sees the plane from the ground and the other sees the ground from the plane point of view. Exceptional. If I read the post right. Please post the web site that has info on this item.

W1HRM, AMA 353682, AF11316785,

Dan Thomps> >

Reply to
jim breeeyar

Reply to
steven baker

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.