Hi All
>
>I would like to know is it possible to dual dimension only some of the
>dimensions on a drawing?
>When I use alt units it seems to do all the dims!
You should be able to apply it to specific dimensions using an override.
You should be able to apply it to specific dimensions using an override.
All right I give up have tried the overrides but still can't seem to suss it.
Regards
Have you tried using multiple dimstyles? (One for single dimension, one for alternate units.)
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.