1. Home
  2. AutoCAD discussions
  3. re-establish origin?

re-establish origin?

if I have a file I would like to move the origin to 0,0,0 . so when I load
as an xref it loads in the correct spot?
thanks
Reply to
longshot
Loading thread data ...
Does INSBASE also affect xref insertions? I dunno...
Reply to
Michael Bulatovich
Just looked it up, it does. Reset it as required.
Reply to
Michael Bulatovich
FOR MY INFORMATION:
how is this different from UCS WORLD?
Reply to
roy
Open the file then enter : BASE 0,0,0
Philippe
Reply to
Philippe

Further Reading

  • Move the origin to another plane

  • Hi People,I made a sketch on the top plane and I extruded it up to ± 50mm.Than...

  • Origin

  • How do I move the origin in 3D?

  • Mating to origin

  • drag the part into the assy but instead of letting go in the design areadrag to...

  • drawing at origin

  • Usually I design in the middle of the screen? and sometimes I need aDXF file of...

  • Origin of Hex Head Nuts/bolts?

  • On 5 Jun 2004 20:29:53 -0700, jim rozen stated, with eyes & arms akimbo:If you...

  • Goodbye origin

  • Well, I found a new way to break a part, playing with Insert>Features>Shape.Try...

  • Dumb(?) Origin Question

  • Hi,First, I make all of my parts, paying close attention to front, back, right...

  • HPGL: setting plot origin

  • Hi everyoneI have a problem. I have to set the plot origin to the center of...

  • Origin Showing in Drawings

  • Whenever I create a new drawing, it shows (And prints) the origin ofevery part....

  • Origin (move), -or- "did" the pooch on this one...

  • Hello, OK, this is going to be boring. Also, you will ask yourself"why did he do...

  • safest way to move file?

  • I have a few projects on my local workstation and I would like to move themto...

  • Re: Tip of the Day: Matching Sketch Origin to Part's

  • Mike, I give up! I've tried and followed your instructions to the letter....

  • RE: Offset -->Origin Point ?

  • Hi there, just another quick one.I use a template which I've been using...

  • C of G on Origin

  • I posted once on this newsgroup and asked for a macro that would locate...

  • how to draw cam contour?

  • Hi, I have a cam contour,but I don't know how to draw it with is data Base...
  • « previous thread

  • '@' key Problems in ADT 2006

  • I'm fairly new to ADT 2006, and wonder if any one has had problems with the...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.