Until you have downloaded the offline version to the simulator, the two will always be different - so there's no problem.
Dirk Desart wrote:
Until you have downloaded the offline version to the simulator, the two will always be different - so there's no problem.
Dirk Desart wrote:
Thanks for answering my question. After all I was not so clear about my problem. The conflict appears much earlier before the step 7 program was made. As far as I know (I am a beginner) the normal way of working with the simulator goes like this: I make a new project. Then I assemble the hardware configuration of the PLC in the SIMATIC Manager. After that I download the configuration to the simulator. I think normally the simulator accepts this configuration but here it goes wrong. The strange thing is, I installed this simulator on another computer and there it works.
Kind Regards,
Dirk Desart
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.