⧑ Industrial Control Group

  1. Home
  2. ⧑ Industrial Control Group
2150 Threads Posts
to

Motor Phase Output

I am looking at getting a particular servo drive to learn but being new to the game I dJ3 - Motor Phase Output 1 SHIELD...
1 comments posted 21yrs
posted by orc_general
1 comments posted 21yrs posted by orc_general

Looking for copy of manual for Gulton/West 2050

Anyone have a copy of the programming manual for the West 2060 furnace controller? Gladly pay for your copy postage. Ema...
0 comments posted 21yrs
posted by w8ron
0 comments posted 21yrs posted by w8ron

Magnetic switch?

Is there such a thing as a magnetic switch or sensor that would sense a magnet in the range of 12"-6" away?
4 comments posted 21yrs
posted by dotnet_vb_newbie
4 comments posted 21yrs posted by dotnet_vb_newbie

PWM inside feedback loop

Hi I'm attempting to control a brushed DC motor using an analogue PWM chip inside a feedback loop. I'm currently doing...
1 comments posted 21yrs
posted by ela01srm
1 comments posted 21yrs posted by ela01srm

PWM inside linear feedback loop

Hi I'm attempting to control a brushed DC motor in troque control with an analogue pwm chip. I have the chip inside a f...
0 comments posted 21yrs
posted by stephen.minshull
0 comments posted 21yrs posted by stephen.minshull

PROFIBUS Device Operating Parameters

Hi, I am modeling the working of PROFIBUS for a university project and I do not have any practical experience with PROF...
1 comments posted 21yrs
posted by vinayinfosec
1 comments posted 21yrs posted by vinayinfosec

Wanted: EE with 1760 bus experience

A client of mine needs someone on a contract basis to deal with the electronics interface of a 1760 bus. Reliability is...
0 comments posted 21yrs
posted by sporkedUNDERLINEagainMUNGE
0 comments posted 21yrs posted by sporkedUNDERLINEagainMUNGE

Low Cost I/O Recommendations Wanted

I recently had a request for some information totally outside of my field, so I want to see if others have the informat...
5 comments posted 21yrs
posted by nitarichard
5 comments posted 21yrs posted by nitarichard

Stepper Motor Contoller

I want to control a unipolar stepper motor with a phase current of 1 amp and a 0.37mNm holding torque, it also has 8 le...
2 comments posted 21yrs
posted by 0141666
2 comments posted 21yrs posted by 0141666

sy/max square d for sale

here is a list SQUARE D MODEL SY/MAX 400 Processor 5 SY/MAX 8030 RIM 125 1 CRM 510 4 CRM 210 2 SY/MAX 300 Processor 1 8...
0 comments posted 21yrs
posted by gewart
0 comments posted 21yrs posted by gewart

Limit switch to control motor

Need some advice.. I am designing a small feed system for lumber grading. This feed system is part of a lumber grading...
4 comments posted 21yrs
posted by npirollo
4 comments posted 21yrs posted by npirollo