Best way to knurl?

Is it best to sweep it across the area on each pass, gradually increasing
the pressure, or is it best to focus on an area until the required depth is
reached and then to shift to an adjacent area etc?
jmc
Reply to
jmc
Loading thread data ...
Crank in the pressure until the knurl is cutting to full depth and pattern, then traverse it across the area to be knurled. In other words, you can't be timid when knurling. You have to crank it. With a light lathe, this is best done with a scissors knurling tool.
Gary
Reply to
Gary Coffman

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.