Battery charger's SPS blew a resistor on the input side during plug-in (no "on-off" switch).
Simplest way to prevent similar occurrence in future?
Thanks,
Adding surge protection to a SPS?
Jul 01, 2004
1 Replies
First reply
Replace same value resistor with a larger wattage. This assumes the resistor blew not due to other internal component failures. Caution: sometimes these resistors are fire retardant type because they double as a 'fuse like' device. They blow when something else, such as an…
Read the full replyReplace same value resistor with a larger wattage. This assumes the resistor blew not due to other internal component failures.
Cauti> Battery charger's SPS blew a resistor on the input side during
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required