Adjusting pots on tube of monitor while switched on

Andy · 2006-05-02T12:40:18+00:00

I am in the UK.I have been cleaning out the dust from the inside of my monitor and I just moved a few pots to make sure their tracks are clean and returned the pots to how they were.In fact the only pots I can find are three right next to the coil on the neck of the picture tube and they are marked: Y-HC: Y and in small letters, HC Delta V: capital delta symbol then V YV: Y and in a small letter, VWhat do these do?To be prfectly honest I think I may have not quite returned them to their original postion but might be 20 or 30 degrees out. Can I adjust them with the monitor on? Of course I won't be touching any HT parts but I wonder if they are inherently too close to the HT to adjust while the monitor is on? Must I use an insulated trimming tool rather than a meta scredriver?

May 02, 2006 60 Replies

Rate this thread:

Alex Coleman 20 years ago

Now I thought people here were saying that the a shock from the back of a TV would make you get thrown across a room but that it would

*not* kill you.

What you now say confuses me.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required

Adjusting pots on tube of monitor while switched on

Related discussions

Hurco monitor

TIG welding a T-joint

Making Molds On a POS Manual Mini Mill

Join the Discussion

Didn't find your answer?