Most creature figurines of this kind end up printed as one solid chunk, with every overhang and small detail fighting the same print. This build takes the opposite route: it is a multi-part assembly of a red monster figure, named Glare, designed to function as a shelf guardian. Splitting the model into separate pieces is, in my view, what lets a shape like this come out looking tidy instead of scarred by supports.
The parts list is nicely varied. There are red body halves, a beige jaw and a beige belly, five white eyeball pieces with black pupils, two white teeth, and two curved beige horn pieces. Assembly runs on brush super glues, spread with a small black applicator bottle. A rectangular alignment pin sits in a central slot to keep everything lined up while the glue grabs.
The order of operations looks well planned. Adhesive is spread across the flat inner face of the rear red half, then the front and back halves are lined up and pressed together. The beige piece forming the lower jaw and round belly is pressed home into the recess of the chest. Each white eyeball is pressed by hand into a socket shaped to receive it, and the two horns push into holes at each side of the head.
The colour separation is a highlight: red body, beige jaw and belly, white eyes and teeth. One open question is how the hands, the jaw overhang and the ears were printed, since those areas might require support for a clean surface, and the maker has not covered that. The finished figure is shown held in both hands, which suggests a satisfying shelf presence.