ABAQUS Problem

I am trying to assign the geometric coordinates to nodes in ABAQUS
using parameter, but as son as analysis starts, it terminates with
error:
***ERROR: INVALID FLOAT VALUE
LINE IMAGE: 1, 0.*
1, 0.*1
How to make it possible?? please guide on how to use parameter with
coordinates for nodes.
Reply to
Mubeen
Loading thread data ...
In article , Mubeen writes
You do this for example: ** *PARAMETER x1 = 1.0 y1 = 1.0 z1 = 5.0 x2 = 2.0*x1 y2 = 2.0*y1 z2 = 10.0*z1 ** ** add any more parameters ** ** Now set up model: *NODE 1 , ,
Reply to
Martin Goldthorpe

Site Timeline

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.