Bench grinders crap?

I've seen some grinding wheels with a center hole plugged with a grey material (?sulfur) which is then precisely bored to the shaft dimension plus a small tolerance... if you tighten the flanges on such a wheel, if it is bored slightly askew, you'll bend the shaft and everything goes wobbly.

Reply to
whit3rd
Loading thread data ...

Epoxy. If from a good supplier, the hole will be perpendicular to the faces.

Joe Gwinn

Reply to
Joe Gwinn

whit3rd fired this volley in news: snipped-for-privacy@googlegroups.com:

Right. Sulfur. L

Reply to
Lloyd E. Sponenburgh

Joe Gwinn fired this volley in news:070920151847203238% snipped-for-privacy@comcast.net:

If from a BAD supplier, if they've gone to the trouble of plugging and re- drilling the center hole, it's going to be as true as it needs to be.

Lloyd

Reply to
Lloyd E. Sponenburgh

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.