bench top height question for mini-mill

mj · 2005-10-19T14:40:12+00:00

Hey,I am trying to determine a good height for my workbench for amini-mill. I am getting one of the cheap Chinese ones like the Grizzlyor Cummins brands. My workbench for my lathe is at 40" and it is quitecomfortable for me. I am somewhere around 6'0 to 6'1" tall. Should Ikeep the mill bench the same height or slightly lower? I am not gettingthe mill until later this winter or early spring, but I need to get thematerials for my bench out of the place that is storing it. Plus thefact that I could use the room. I had thought of keeping it at 40" andcutting it down if needed. However, that is a lot of work to go throughand I would just as soon as get it right the first time.I already searched for an answer on this and I could not find anything.ThanksMike

Oct 19, 2005 42 Replies

Rate this thread:

Rex B 20 years ago

LOL whatever gave you THAT idea?? Yeah, chinese horses are a little different. Don't bet on one :)

So...not sure what I am going to do. I might run over to Sioux

I have no idea. It's an older HF unit I bought used.

I'm just a little hesitant

Mike, I've never stalled the motor on mine. When the blade hangs, the belt slips, but the motor keeps turning. I suspect even 1/3 hose is plenty. 3/4 HP seems way too much.

The only issues I'v heard of with motors on any of them is that some of them just burn up early. No pattern to it, they either smoke early on, or they last for years. At any rate, those motors are cheap. Probably a washing machine motor would be a no-cost upgrade if the original ever failed.

Vote

mj 20 years ago

Hey Rex, For better or worse, I just bought a $169.99 HF bandsaw. I bought a couple of extra blades. They did not say whether they were bi-metal though. I got a 10 tpi and an 18 tpi.

I figure if the motor burns up, I'll put the 2 hp from my table saw on the thing and give it some real power. That might be overkill though. LOL Thanks again for all the help. This thread went all over the last couple of weeks. I originally posted my workbench height question and ended up with a bandsaw by the time we all got done. Cool. Mike

Vote